|
[Sponsors] |
[ANSYS Meshing] Applying share topology takes too much time |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
October 28, 2023, 10:08 |
Applying share topology takes too much time
|
#1 |
New Member
Oğuzhan Alasulu
Join Date: Oct 2023
Posts: 2
Rep Power: 0 |
I'm working on a CAD oven model in Ansys Fluent Meshing. All previous steps ( local sizing, generating surface mesh, and, geometry describing) were successfully completed. As the users know, applying sharing topology is an obligation for CAD model in ansys meshing (as meshing warns me at least), but this steps takes excessively much time. What is your suggestion?
|
|
Tags |
ansys, meshing, topology |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Other] Contribution a new utility: refine wall layer mesh based on yPlus field | lakeat | OpenFOAM Community Contributions | 58 | December 23, 2021 02:36 |
Slow calculation time on CFD server | killian153 | Hardware | 4 | July 27, 2021 07:28 |
AMI speed performance | danny123 | OpenFOAM | 21 | October 24, 2020 04:13 |
How to write k and epsilon before the abnormal end | xiuying | OpenFOAM Running, Solving & CFD | 8 | August 27, 2013 15:33 |
mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 09:34 |