 |
 |
 |
|
|
|
[Sponsors] | ||||
March 4, 2024, 17:30
|
Meshing of cylindrical column in ICEM
|
#1 |
|
New Member
Join Date: Nov 2023
Posts: 7
Rep Power: 2  |
Hi there,
I am trying to make a cylindrical mesh with three circular inlets at the bottom, using ICEM (see attached picture). My problem is that some of the blocks at the edges get some cells that are very squished (circled in red). I was wondering if anyone know how to go about avoiding/improving these blocks? Any help would be really appreciated! |
|
|
|
|
| Tags |
| icem |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing of rectangular bubble column | SphericalCube | Mesh Generation & Pre-Processing | 0 | November 22, 2023 07:50 |
| [Gmsh] gmshToFoam generates patches with 0 faces and 0 points | Simurgh | OpenFOAM Meshing & Mesh Conversion | 4 | August 25, 2023 08:58 |
| Using ICEM CFD to repair/edit ANSYS Meshing | Kaaji1359 | ANSYS | 2 | July 30, 2013 11:28 |
| [ICEM] Meshing adjacent wall geometry and simple ICEM questions | everdimension | ANSYS Meshing & Geometry | 25 | June 20, 2012 05:25 |
| [ICEM] ICEM meshing problem | xyq102296 | ANSYS Meshing & Geometry | 6 | October 28, 2010 11:09 |
Threaded Mode
