|
[Sponsors] |
July 22, 2013, 19:29 |
Using ICEM CFD to repair/edit ANSYS Meshing
|
#1 |
New Member
Jeff
Join Date: Jun 2013
Posts: 8
Rep Power: 13 |
Hello,
From what I've seen on these forums, ICEM CFD is a much more powerful meshing tool than ANSYS Meshing (we are on ANSYS 14.5). However, due to licensing reasons, obtaining ICEM CFD licenses for everybody is unrealistic. However, ICEM CFD has many post-processing options that ANSYS Meshing doesn't have. My question is: is importing an ANSYS Mesh into ICEM CFD to run ICEM's Mesh Repair tools worth it, or does the ANSYS Mesher already do a good enough job? Is ICEM CFD only useful if you build the mesh from the ground up? Basically, if our group only uses ICEM CFD to repair the mesh generated by ANSYS Meshing, then we would save a lot of licenses. Thanks for your help. |
|
July 24, 2013, 12:10 |
|
#2 |
New Member
Jeff
Join Date: Jun 2013
Posts: 8
Rep Power: 13 |
Nobody has any experience with ICEM CFD's repair tools at all?
|
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ANSYS Meshing] How to pop the hood on ANSYS Meshing to access ICEM CFD... | PSYMN | ANSYS Meshing & Geometry | 3 | October 4, 2012 20:41 |
[Other] Ansys Meshing vs Ansys ICEM CFD | JuPa | ANSYS Meshing & Geometry | 5 | September 19, 2012 10:48 |
[ICEM] ANSYS ICEM CFD YouTube Tutorials | mech.ismail | ANSYS Meshing & Geometry | 1 | September 4, 2012 13:19 |
[ICEM] 2d Aerofoil meshing in ansys ICEM | syler3321 | ANSYS Meshing & Geometry | 2 | February 3, 2012 02:59 |
ANSYS ICEM CFD smoothing mesh corner chamfered | Hans | CFX | 4 | January 26, 2006 17:00 |