 |
 |
 |
|
|
|
[Sponsors] | ||||
April 28, 2009, 06:32
|
ICEM: setting tolerance
|
#1 |
|
Senior Member
Join Date: Apr 2009
Posts: 118
Rep Power: 17  |
Hi,
When creating a surface using ICEM it asks for a tolerance and I'm not sure what value to enter. Lets say I have a cuboid with the following dimensions, l=1 m, b=0.00017 m and h=0.07 m. If I were to create surfaces on each of the six side what would I set the tolerance to be? Would it be a value less than 0.00017m? Thanks. |
|
|
|
|
| Tags |
| icem tolerance |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ICEM working directory setting | Bogesz | CFX | 2 | October 8, 2008 07:45 |
| Tri Tolerance in ICEM Hexa | Mohammad Faridul Alam | CFX | 1 | November 21, 2007 10:55 |
| ICEM Default Setting Customization | Amod Kumar | CFX | 0 | September 17, 2007 03:57 |
| About Mesh size setting in ICEM | Eric | CFX | 2 | July 11, 2006 08:16 |
| Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Threaded Mode
