 |
 |
 |
|
|
|
[Sponsors] | ||||
May 2, 2009, 03:36
|
[ICEM] 3D wing tip
|
#1 |
|
New Member
Join Date: May 2009
Posts: 21
Rep Power: 17  |
I am using ICEM hexa to model a 3D wing with a Naca 0006 profile attached to a wall. I am wondering what kind of blocking structure is suitable for the wing tip.
An O-grid works fine for the Wing section near the wall, as that resembles a 2D construction, but at the tip, it is not so clean. I get relatively low quality (0.2) and very low angles (4). I have basically put an O-grid around the whole wing, Also I am not using degenerate blocking, so the trailing edge is modelled as a thin flat edge Thanks. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 3D Wing Analysis | Ed | FLUENT | 5 | April 13, 2019 13:07 |
| Forward swept wing simulation | abid | Siemens | 1 | June 16, 2012 13:26 |
| How to model vortex of supersonic wing tip | Bernard | FLUENT | 0 | January 29, 2007 03:20 |
| Wing tip vortices using Fluent | Jainy | FLUENT | 3 | August 22, 2005 19:13 |
| Delta Wing Structured Grid | Riaan | FLUENT | 3 | December 31, 2004 12:03 |
Threaded Mode
