|May 11, 2009, 08:00||
Join Date: Apr 2009
Posts: 16Rep Power: 10
I am meshing a fan model I want to mesh it by tetra mesh, i am using the ICEM CFD software. The fan model has two parts one is rotor (impeller) and other one is the volute(stator). It is a centrifugal fan. The impeller is having the front shroud rear shroud and the blades. i want to mesh but there shoud be two domains meshed separately in one geometry. One is the stator and another one is the rotor. Is it possible? if so then how?
the same propblem i have to solve in cfx there i have to give gthe interface between stator and the rotor? there is some common surface.
give some idea.
|Thread||Thread Starter||Forum||Replies||Last Post|
|Turbomachinery at OpenFOAM Workshop Milan 2008||hani||OpenFOAM||0||March 21, 2008 03:33|
|best CFD software for turbomachinery||sam||Main CFD Forum||10||April 13, 2007 15:42|
|GAMBIT and Turbomachinery||tom||Main CFD Forum||6||October 21, 1999 09:50|
|Turbulence in Turbomachinery||Erich F.||Main CFD Forum||15||June 22, 1999 23:37|
|ERCOFTAC Seminar and Workshop on TURBOMACHINERY FLOW PREDICTIONS VII||Stephane AUBERT||Main CFD Forum||1||October 9, 1998 16:37|