[fluentnoob]

Hi Everyone,

I was trying to mesh the flow volume around a small marine vehicle which I'm working on. I followed the steps in the "GAMBIT: Sailboat Tutorial". But when I try to go ahead with tetrahedral volume meshing, it gives me the following error:

"Initialization failed, perturb boundary nodes and try again.
ERROR: TG_Mesh_Domain failed with error code 1
ERROR: Tetrahedral meshing has failed for volume volume.1
This is usually cause by problems in the face meshes
Check the skewness of the face meshes and check that the face mesh sizes are not too large in the areas of small gaps."

Can anyone please tell me that how do I go about correcting this?

Thank you.