|
[Sponsors] |
November 30, 2009, 14:56 |
highly skewed elements in grid
|
#1 |
New Member
ryan robinson
Join Date: Nov 2009
Posts: 8
Rep Power: 16 |
I was trying to mesh a face with around a 2d airfoil.But after meshing the face it shows that i have 18 highly skewed elements.How do i remove them.
|
|
December 1, 2009, 23:18 |
|
#2 |
New Member
Dr Suvash C Saha
Join Date: Nov 2009
Posts: 24
Rep Power: 16 |
I am also facing the same problem. Anybody here to help?
|
|
December 2, 2009, 01:24 |
|
#3 |
New Member
Dr Suvash C Saha
Join Date: Nov 2009
Posts: 24
Rep Power: 16 |
I have found a way. However, I don't know whether it is right way or not! Just go to Grid->Polyhedra->Convert Skewed Cells. I found it in the UG of fluent.
|
|
December 2, 2009, 02:41 |
|
#4 |
Super Moderator
Maxime Perelli
Join Date: Mar 2009
Location: Switzerland
Posts: 3,297
Rep Power: 41 |
there is always a reason for skewed cells.
Try to found this reason (small edge, small angle etc...) If you don't see any geometrical reason, then try to "play" with mesh parameters (size function etc....)
__________________
In memory of my friend Hervé: CFD engineer & freerider |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Can highly skewed elements create problem?? | Sanjay Jain | FLUENT | 1 | April 8, 2008 15:57 |
help: the volume mesh has highly skewed elements | xiaofish | FLUENT | 3 | September 18, 2007 09:51 |
what to do w/ highly skewed elements? (GAMBIT) | mike | FLUENT | 5 | June 2, 2007 22:10 |
Highly skewed elements | Hengky | FLUENT | 2 | August 11, 2005 12:17 |
CFX4.3 -build analysis form | Chie Min | CFX | 5 | July 12, 2001 23:19 |