|
[Sponsors] |
January 18, 2010, 15:40 |
Hex - prism - hex icem
|
#1 |
New Member
Adam R
Join Date: Jul 2009
Posts: 7
Rep Power: 16 |
I have a geometry that can be meshed nearly completely with a structured 3d hex mesh, but there is a triangular bit which would need some prisms to remain structured, the ideal solution i have in mind is sketched in 2d in the attachment.
Can this be done? - is there a tutorial? - Where should I be looking? Thanks for any assistance Adam |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM - problems with prism mesh | João Lourenço | CFX | 2 | September 18, 2019 03:07 |
Getting prism to inflate into mixed tet-hex meshes | Joe | CFX | 16 | October 10, 2011 07:06 |
ICEM Prism Layer transition between surface with prism layers and one without | TWaung | ANSYS Meshing & Geometry | 2 | October 12, 2009 14:56 |
CheckMeshbs errors | ivanyao | OpenFOAM Running, Solving & CFD | 2 | March 11, 2009 02:34 |
ICEM - Prism Tool Problem | carpe85 | CFX | 0 | February 10, 2009 12:25 |