|
[Sponsors] |
[ICEM] ansys icem tetra mesh to fluent_v6 conversion problems |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
May 2, 2010, 04:33 |
ansys icem tetra mesh to fluent_v6 conversion problems
|
#1 |
New Member
Vasu
Join Date: Oct 2009
Posts: 17
Rep Power: 16 |
Hi all,
I have a tetra mesh with prism layers generated in Ansys ICEM, I've attached a picture below. Now when I use fluent_v6 solver to export the mesh so I can use it for my simulation in OpenFOAM. It converts the mesh, but skips the parts, INLET, OUTLET and ROTSYMM2. Also it creates shadow faces instead of the ROTSYMM2 part. Basically ROTSYMM1 and ROTSYMM2 are the sides of the grid that are periodic. To explain a bit more, the grid is periodic and axisymmetric and it is a wedge of 5 degrees part of a cylindrical set up. I have set the rotational periodicity in the global mesh set up part. Any help on how to get all the parts required for my boundary definition would be very welcome! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM 2D tetra mesh question | kawamatt2 | ANSYS Meshing & Geometry | 18 | March 3, 2014 10:56 |
Exporting ICEM Tetra Grid to Fluent with Hexa-Core | Tim | FLUENT | 2 | August 30, 2007 07:16 |
ICEM clustering of mesh points and multiple edges | webhaw | CFX | 4 | July 25, 2007 16:29 |
how to export mesh from ICEM CFD to Ansys | siv | CFX | 10 | March 23, 2006 08:19 |
How to do Geometry from 3D mesh in ICEM | San24 | Main CFD Forum | 4 | August 8, 2005 02:49 |