|
[Sponsors] |
[ANSYS Meshing] How to adjust mesh size for nano meter pipe |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
April 23, 2017, 09:32 |
How to adjust mesh size for nano meter pipe
|
#1 |
New Member
Muhammad Javaid Afzal
Join Date: Apr 2017
Location: Pakistan
Posts: 1
Rep Power: 0 |
Hi everyone. i am facing a problem in mesh analysis. i have designed a nano size pipe but mesh check is failed. simulation is done up to mm size but not for micro and nano. what i have to do. pl anybody can tell
javaid |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[snappyHexMesh] SnappyHexMesh no layers and no decent mesh for complex geometry | pizzaspinate | OpenFOAM Meshing & Mesh Conversion | 1 | February 25, 2015 07:05 |
engrid -> save as .stl with boundarie codes | Zymon | enGrid | 31 | August 29, 2011 13:40 |
critical error during installation of openfoam | Fabio88 | OpenFOAM Installation | 21 | June 2, 2010 03:01 |
[GAMBIT] 3D mesh for pipe intersection | pranab_jha | ANSYS Meshing & Geometry | 3 | May 28, 2010 01:33 |
OF 1.6 | Ubuntu 9.10 (64bit) | GLIBCXX_3.4.11 not found | piprus | OpenFOAM Installation | 22 | February 25, 2010 13:43 |