|
[Sponsors] |
June 1, 2010, 10:48 |
ICEM Frustration
|
#1 |
New Member
Tim Hannah
Join Date: Jun 2010
Posts: 7
Rep Power: 16 |
Hey Guys,
I'm completely new to this whole thing and have been trying to run through some tutorials. However it wasn't long before I became hopelessly stuck. I cannot for the life of me figure out how to create a surface from curves. I've created the curves, and when I go to create my surface from "2-4 curves" i click the desired curves but they don't appear in the "Curves" box and the surfaces don't appear in the left hand side box. Heres a screenshot, So I select the 4 outside curves then click "apply" and nothing happens I know there must be such an easy fix for this... I just cannot work it out. Thanks. |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
ICEM BC to FLUENT | Simon | CFX | 3 | September 9, 2008 17:08 |
Design Modeler to ICEM..... | Joe | CFX | 0 | January 24, 2008 03:39 |
ICEM 10 mesh scale foe CFX | Korsh Mik | CFX | 2 | October 7, 2005 09:07 |
ICEM CFD 5.1 Hex-Tet mesh merging failure | bogesz | CFX | 1 | January 29, 2005 06:46 |