 |
 |
 |
|
|
|
[Sponsors] | ||||
September 1, 2010, 22:35
|
why is the edge color changed?
|
#1 |
|
Member
Join Date: Dec 2009
Location: China
Posts: 79
Rep Power: 16  |
When I open the project, I will find the color of some edges have changed. As the following picture show, it changed to black.
1.jpg But, if I turn off 'Edges' and then turn it on, the color will come back. 2.jpg What's the matter? And when I check the mesh quality, as the below picture show, there are some elements between 0.714717 and 0.72898075. But when I lighten the bar, I can't find anything. And the message is showed as below. 3.jpg 0.714717 -> 0.72898075, 1 values 0 elements Anybody can help me? Thanks very much. |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Meshing a Sphere | Ajay | FLUENT | 10 | September 3, 2016 14:18 |
| Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
| Where's the singularity/mesh flaw? | audrich | FLUENT | 3 | August 4, 2009 01:07 |
| fluent add additional zones for the mesh file | SSL | FLUENT | 2 | January 26, 2008 11:55 |
| [Commercial meshers] Star mesh import problem | chris1980 | OpenFOAM Meshing & Mesh Conversion | 20 | May 8, 2006 01:07 |
Threaded Mode
