[hadikhayyamian]

Hi all,

I was wondering the difference of assigning boundary conditions in Gambit and doing the tha same job in Fluent again.

For example, when I make my geometry in Gambit, I have to define boundary conditions types (say, I select a face as inlet velocity) then I am asked to put its value (velocity magnitude is asked).
But my problem is that when I finish working with Gambit and have to open the meshed file in Fluent Solver, Again I am asked to put associated values for each Boundary Conditions (While I have earlier assigned them in Gambit).

I would like to know why these input values are asked twice?

It would be greatly appreciated, if u reply!

Regards.