[ICEM] Bad elements in the narrow gap -- CFD Online Discussion Forums

January 21, 2011, 13:06	Bad elements in the narrow gap	#1
saisanthoshm88 Senior Member --------- Join Date: Oct 2010 Posts: 303 Rep Power: 17	I was making a Tet mesh to a geometry which had a very narrow gap between two surfaces , the volume elements between the two surfaces were too worst. It was as if the elements got crushed in between the surfaces To resolve the problem i've tried the 'Define thin cuts' option but that didn't help. Can some one please suggest on overcoming the problem. __________________ Best regards, Santhosh.

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts BB code is On Smilies are On [IMG] code is On HTML code is Off Trackbacks are Off Pingbacks are On Refbacks are On Forum Rules

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[ICEM] Solar Water Heater Mesh Problem.	OzMantle	ANSYS Meshing & Geometry	17	July 27, 2010 19:14
criterion for bad elements in ICEM-CFD??	Ravi	CFX	0	April 3, 2008 12:07
High Aspect Ratio elements	Flavio	CFX	2	November 24, 2006 12:01
Penetrating elements in extruded mesh	Michael P	CFX	2	May 20, 2005 08:06
CFX4.3 -build analysis form	Chie Min	CFX	5	July 12, 2001 23:19

All times are GMT -4. The time now is 08:07.