|
[Sponsors] |
April 8, 2011, 16:10 |
cylinder pipe
|
#1 |
New Member
asal
Join Date: Apr 2010
Posts: 11
Rep Power: 16 |
I made a cylinder in gambit,I put the circle face of this cylinder as inflow and the other circle outflow.but when
I put it in fluent and start it,it gives me floating point error.without any iteration.what is the problem?who knows?Is the problem from my set up in fluent or my model in gambit?just by making cylinder,will fluent know it as pipe? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] DesignModeler Pipe within pipe | shields | ANSYS Meshing & Geometry | 13 | November 25, 2018 22:14 |
[blockMesh] Specifying boundary faces failes in blockMesh | blaise | OpenFOAM Meshing & Mesh Conversion | 0 | May 10, 2010 03:56 |
Turbulent flow in a cylinder pipe | SeRGeiSarov | Main CFD Forum | 0 | March 25, 2010 13:20 |
Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 09:11 |
fluid flow fundas | ram | Main CFD Forum | 5 | June 17, 2000 21:31 |