|
[Sponsors] |
April 16, 2019, 07:35 |
single edge ICEM
|
#1 |
New Member
FengPengyu
Join Date: Apr 2019
Posts: 1
Rep Power: 0 |
Hello everybody,
Recently, I completed the grid division of proton exchange membrane fuel cells in ICEM CFD. single edge and uncovered face problems occurred during grid inspection. after the uncovered face problem was automatically fixed, separating wall and removing unreferenced faces appeared after the grid was imported into Fluent. thank you all, rainst. Last edited by rainst; April 18, 2019 at 21:11. |
|
Tags |
separating wall, single edge, unreferenced face |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[TurboGrid] turbogrid to icem cfd then icem cfd to fluent | tmeysam92 | ANSYS Meshing & Geometry | 0 | May 7, 2014 06:25 |
Export mesh from ICEM CFD for Fluent | summerdream | ANSYS | 2 | September 10, 2013 12:12 |
Transport mesh from ICEM CFD, to Fluent, to Sysnoise | Wieland | FLUENT | 2 | April 15, 2012 06:28 |
Dimension conflict between icem cfd and fluent | highhopes | ANSYS Meshing & Geometry | 1 | September 9, 2011 11:07 |
[ICEM] Export unstructured periodic mesh from ICEM CFD to Fluent | ivanddd | ANSYS Meshing & Geometry | 1 | February 3, 2011 00:51 |