|
[Sponsors] |
July 18, 2011, 11:37 |
ICEM aircraft mesh trailing edge difficulty
|
#1 |
New Member
Monty Roberts
Join Date: Jul 2011
Posts: 4
Rep Power: 14 |
I am having a problem with meshing trailing edges. I have tried to associate the mesh with the edge curves. This does not seem to work.
The trailing edge of the root fillet is also a problem. I'm a newb so feel free to point out any obvious problems, they are probably not obvious to me.... Any tips? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[ICEM] Hexa mesh, curve mesh setup, bunching law | Anorky | ANSYS Meshing & Geometry | 4 | November 12, 2014 00:27 |
fine mesh in wake trailing edge | jose antonio | ANSYS Meshing & Geometry | 1 | August 11, 2011 19:10 |
ICEM Tetra mesh, Size reduction and Skewness problem | Catthan | ANSYS Meshing & Geometry | 6 | December 5, 2010 19:39 |
Actuator disk model | audrich | FLUENT | 0 | September 21, 2009 07:06 |
Mesh from ICEM CFD to CFX ! Error ! Why ? Thanks ! | Vu Trinh Tuan | CFX | 11 | March 28, 2005 19:04 |