|
[Sponsors] |
July 20, 2011, 00:32 |
2d Aerofoil meshing in ansys ICEM
|
#1 |
Member
|
Hi,
I noticed that in the ansys icem meshing video on aerofoil (Part 1/3 at 1.11 minute), Simon managed to get an edge that is curved at the leading edge. How did he do this? This is the video link:- http://www.youtube.com/watch?v=tYrbScUH9RE Another question is: i'm trying to mesh a triangular mesh around my aerofoil with a prismatic layer but i cannot seem to do this. I created a surface, cut the aerofoil from the surface, go to global mesh and set all the criteria. In Shell meshing parameters i set it as all tri. Then i go to prism meshing parameters and set my layers and i even turned on the 2d boundary layer in advanced prism meshing parameters. When i clicked compute mesh, no mesh appeared. Did i miss a step? Regards Ralph |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Strange ANSYS Meshing 13.0 Problem | brunob | ANSYS Meshing & Geometry | 3 | June 21, 2011 20:03 |
[ANSYS Meshing] Ansys Meshing Vs ICEM | jocarsa | ANSYS Meshing & Geometry | 2 | May 10, 2011 04:33 |
Mesh generation tool | AMusteykis | ANSYS Meshing & Geometry | 7 | March 22, 2010 12:06 |
Missing tets along line when meshing with ICEM CFD | Georges P. Côté | CFX | 6 | March 23, 2006 00:34 |
Icem Hexa 2d aerofoil meshing | Ste Lakey | CFX | 0 | August 25, 2004 07:05 |