|
[Sponsors] |
July 21, 2011, 10:39 |
Cell Numbering
|
#1 |
New Member
Join Date: Jun 2011
Posts: 5
Rep Power: 14 |
Hi all, I'm currently trying to interpret an exported ASCII file from ANSYS meshing. I've made sense of quite a lot of the information about faces and nodes but I'm struggling with information about whole cells.
Does anyone know of a way to display cell numbers in ANSYS meshing to try and help me understand how the file works? Any help, advice, or ideas would be greatly appreciated! |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Cells with t below lower limit | Purushothama | Siemens | 2 | May 31, 2010 21:58 |
[Technical] Cell numbering | sega | OpenFOAM Meshing & Mesh Conversion | 1 | April 20, 2010 11:32 |
[Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
Warning 097- | AB | Siemens | 6 | November 15, 2004 04:41 |
Cell numbering convention | Hassaneen | Siemens | 10 | August 14, 2000 03:36 |