|
[Sponsors] |
September 13, 2011, 03:07 |
cut a face on a volume (real)
|
#1 |
Member
leila
Join Date: Jul 2011
Posts: 35
Rep Power: 14 |
hi max
the pic attached is a spray dryer chamber that hot gas enters it from a ring hole on top of it. I want to creat a ring enterance on the top. is it clear? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
how to set periodic boundary conditions | Ganesh | FLUENT | 15 | November 18, 2020 06:09 |
channelFoam for a 3D pipe | AlmostSurelyRob | OpenFOAM | 3 | June 24, 2011 13:06 |
[Gmsh] Import problem | ARC | OpenFOAM Meshing & Mesh Conversion | 0 | February 27, 2010 10:56 |
gmsh2ToFoam | sarajags_89 | OpenFOAM | 0 | November 24, 2009 22:50 |
[GAMBIT] Difference between real & virtual line, face, & volume?? | teguhtf | ANSYS Meshing & Geometry | 2 | October 5, 2009 07:47 |