 |
 |
 |
|
|
|
[Sponsors] | ||||
November 23, 2011, 21:48
|
Question about Shrink Wrap tutorial
|
#1 |
|
New Member
Join Date: Aug 2009
Posts: 11
Rep Power: 15  |
Hello, I am wondering if anyone has tried the ICEM tutorial "Geometry simplification using Shrinkwrap". Well, I followed the tutorial step-by-step but when I check the mesh quality, unlike what the tutorial document says "there should be no errors in the mesh", there are lots of errors
 . In fact even simple inspection can see two holes at the two ends of the mesh.I followed the instructions of the tutorial exactly. Just like before, every time I use ICEM, I began to doubt IQ, sometimes my IQ, sometimes the software developer's IQ.  If you can help me on this issue, thank you. |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Before you post a question please read this | ghorrocks | CFX | 5 | October 23, 2019 07:44 |
| [Gmsh] 2D Mesh Generation Tutorial for GMSH | aeroslacker | OpenFOAM Meshing & Mesh Conversion | 12 | January 19, 2012 03:52 |
| A question on the first tutorial example bcavityb | athlonshi | OpenFOAM Running, Solving & CFD | 7 | October 23, 2008 11:28 |
| CHANNEL FLOW: a question and a request | Carlos | Main CFD Forum | 4 | August 23, 2002 05:55 |
Linear Mode
