|
[Sponsors] |
December 21, 2011, 09:02 |
Tetrahedral or Hexahedral
|
#1 |
Member
Mina
Join Date: Apr 2011
Posts: 88
Rep Power: 15 |
Dear Ansys users
I am going to mesh a 3D geometry, this geometry is rather simple one, and consisting 2 rectangulars part, 31 tubes with 1mm diameter are coneected to them acting as inlet boundaries, (see the attached file) Geometry.png Now i am wondering that with these small tube which mesh method is better Tetrahedral or Hexahedral ? i am going to mesh it in Workbench and then do CFD analysis, |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Tetrahedral vs. Hexahedral Meshing for CFD | Andy Bartels | Main CFD Forum | 16 | September 20, 2019 10:06 |
tetrahedral or hexahedral mesh? | srr | ANSYS Meshing & Geometry | 4 | September 23, 2010 12:56 |
Tetrahedral and hexahedral mesh based on FVM | kuang | Main CFD Forum | 0 | July 20, 2008 04:52 |
Hexahedral or Tetrahedral | Maria Angelica | Fidelity CFD | 3 | February 19, 2007 00:10 |
hexahedral vs. tetrahedral cells | Christian | Main CFD Forum | 3 | March 21, 2006 06:41 |