 |
 |
 |
|
|
|
[Sponsors] | ||||
December 23, 2011, 10:21
|
Hexa Meshes Distorted Surface
|
#1 |
|
New Member
Jimmy
Join Date: Feb 2011
Posts: 9
Rep Power: 15  |
Hi,
I'm fairly new to ICEM. I'm trying to create a hexa mesh around a half tapered wing, but the rounded wingtip is giving me a lot of grief. As you can see from the images, the mesh around the wingtip is distorted and always ends up distorted at the same spot no matter how I play with the blocking parameters. Anyone knows how this could happen and can offer a hint on how to resolve this? Thanks! |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| GAMG hexa vs. tetrahedron meshes | idrama | OpenFOAM | 11 | September 27, 2018 17:37 |
| [ICEM] Problem making structural mesh on a surface | froztbear | ANSYS Meshing & Geometry | 1 | November 10, 2011 08:52 |
| [Technical] Mesh generation from dirty surface meshes | bastil | OpenFOAM Meshing & Mesh Conversion | 9 | December 10, 2007 11:17 |
| user surface in post | xinzhangabc | CFX | 0 | February 24, 2005 06:29 |
| Hexa Mesh Surface Detection | Achim | Main CFD Forum | 0 | January 21, 2002 18:41 |
Threaded Mode
