[DesignModeler] from total geometry to 1/4

alecon88 · January 31, 2012, 04:59

Hey! I have done a geometry 3D with DM, now my teacher ask me to do 1/4 of geometry.. do you know if there is a tool to cut 3/4 of geometry or if I have to make again?
Thank you

littlebroca · January 31, 2012, 05:28

Hi,
You can use the "Slice" tool to cut the geometry and keep the portion you want.

You can slice by plane (if the default planes are not right for the kind of cut you want, you will have to create a new one), or by surface.

Then DModeler will separate the geometry in several pieces (depending on the slice you will make) and you can keep the one you want.

You'll have to be careful though, when you mesh, and when you define your boundary conditions.

Does that answer your problem ?

alecon88 · January 31, 2012, 08:03

Thank you very much.. Well done

Hybrid · January 31, 2012, 13:05

you can also define symmetry planes to cut 1/4th by making 2 planes and 2 sym.

January 31, 2012, 04:59	from total geometry to 1/4	#1
alecon88 New Member Alessandra Join Date: Jan 2012 Posts: 14 Rep Power: 14	Hey! I have done a geometry 3D with DM, now my teacher ask me to do 1/4 of geometry.. do you know if there is a tool to cut 3/4 of geometry or if I have to make again? Thank you

January 31, 2012, 05:28		#2
littlebroca New Member Tarik Bennani Join Date: Oct 2010 Posts: 6 Rep Power: 17	Hi, You can use the "Slice" tool to cut the geometry and keep the portion you want. You can slice by plane (if the default planes are not right for the kind of cut you want, you will have to create a new one), or by surface. Then DModeler will separate the geometry in several pieces (depending on the slice you will make) and you can keep the one you want. You'll have to be careful though, when you mesh, and when you define your boundary conditions. Does that answer your problem ? PSYMN and alecon88 like this.

January 31, 2012, 13:05		#4
Hybrid Senior Member Ali Join Date: Jan 2012 Location: Pakistan Posts: 134 Rep Power: 16	you can also define symmetry planes to cut 1/4th by making 2 planes and 2 sym. Far likes this.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Total pressure in CFX	famarcfd	CFX	0	June 17, 2011 10:33
car geometry	Arjun	FLUENT	4	September 1, 2007 15:08
vitual _ real	deneb	FLUENT	3	January 22, 2007 04:31
Input Geometry from Ideas to Gambit	Knick	FLUENT	2	December 11, 2002 03:59
Virtual/Real geometry.	Jack Keays	FLUENT	9	June 15, 2000 23:39

January 31, 2012, 08:03		#3
alecon88 New Member Alessandra Join Date: Jan 2012 Posts: 14 Rep Power: 14	Thank you very much.. Well done