|
[Sponsors] |
[ANSYS Meshing] Extruding 2D mesh to 3D mesh in ANSYS meshing |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
February 6, 2012, 09:01 |
Extruding 2D mesh to 3D mesh in ANSYS meshing
|
#1 |
New Member
Rachit Prasad
Join Date: Jun 2011
Location: Blacksburg, Virginia
Posts: 29
Rep Power: 15 |
Hi everyone,
I have been working on a 2D flow over an airfoil in fluent. I had generated the mesh in ANSYS meshing tool. It was an unstructured quad dominant mesh. Now, I have been told to extend the problem in 3D by extruding the same surface mesh in the z direction to convert it into an volume mesh. How could this be accomplished? I know a surface mesh can be extruded in ICEM CFD, but I have been told to do it for the same mesh, so it has to be done in ANSYS meshing only. Thanks in advance! Regards, Rachit |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
2d meshing in ansys meshing | syler3321 | ANSYS Meshing & Geometry | 10 | November 1, 2012 20:42 |
How To save a created mesh file in Ansys Meshing | ashtonJ | CFX | 4 | January 7, 2012 22:04 |
ANSYS meshing help | s.garg | ANSYS | 1 | November 12, 2010 04:11 |
[Other] Ansys meshing - periodic mesh for fluent | jsm | ANSYS Meshing & Geometry | 4 | September 24, 2010 14:25 |
Problem importing ANSYS mesh, please help | Ankan Kumar | FLUENT | 1 | February 2, 2003 08:38 |