|February 16, 2012, 07:54||
ICEM blocking for AUTODYN
Join Date: Feb 2012
Posts: 30Rep Power: 7
I am new in ANSYS and I need to simulate an explosion in AUTODYN. I made the geometry in ICEM, applied repair geometry (topology create), I created Parts and blocks, I associated curves to edges, moved the points to geometry, created pre-mesh and converted to unstructured. I saved the project. Then, when I try to load the .blk file in AUTODYN with Fill block, it sais << Imput file format not consistent >>.
I made all of these reading some tutorials. I can't find an explanation in ANSYS Help.
What I'm doing wrong? Or I must do additonal actions? I'm in air, so please help me.
|autodyn, blocking, icem|
|Thread||Thread Starter||Forum||Replies||Last Post|
|[ICEM] Using Blocking with ICEM (infinite blocking lines appeared)||Touré||ANSYS Meshing & Geometry||2||August 5, 2012 17:27|
|[ICEM] Using Blocking with ICEM (infinity lines appear)||Touré||ANSYS Meshing & Geometry||6||August 5, 2012 17:07|
|No Blocking tab in Ansys ICEM CFD11.0||NewGuy||CFX||1||November 22, 2010 16:38|
|Ansys ICEM 12.0 Searching for tutorial information on complex 3d blocking||Raoul||ANSYS||1||October 18, 2010 06:08|
|ICEM blocking||Chris Wetton||CFX||6||March 9, 2008 06:18|