|
[Sponsors] |
February 21, 2012, 12:50 |
smoothing to single plane
|
#1 |
Member
Vitaly
Join Date: Jan 2012
Posts: 32
Rep Power: 14 |
Hello everyone,
I have a question about meshing to single plane. I have a surface triangle mesh that I am trying to extrude. It looks like the entire mesh is in one plane, but when extruding in the direction of the face normal, that is obviously not the case. Is there a way to smooth a surface mesh to ensure that all the triangle faces are on a single plane? Thanks, Vitaly |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
[Gmsh] Problem with Gmsh | nishant_hull | OpenFOAM Meshing & Mesh Conversion | 23 | August 5, 2015 02:09 |
Meshing a Mixing Plane using ICEM | Will Anderson | FLUENT | 0 | November 6, 2010 17:08 |
[Gmsh] boundaries with gmshToFoam | ouafa | OpenFOAM Meshing & Mesh Conversion | 7 | May 21, 2010 12:43 |
Hexa smoothing (ICEM CFD 10.0) | CFDworker | CFX | 3 | November 2, 2005 10:23 |
P4 1.5 or Dual P3 800EB on Gibabyte board | Danial | FLUENT | 4 | September 12, 2001 11:44 |