[ANSYS Meshing] source line definition

aer · February 20, 2016, 23:05

Hi

How can I define a source line in Ansys meshing to refine the mesh near this source line?

thanks alot

hwet · February 23, 2016, 07:04

edge sizing

aer · February 23, 2016, 14:21

Quote:

Originally Posted by hwet

edge sizing

Thanks for your reply

but , I need to refine mesh near a line that is not physically available, in the other word I need to refine mesh near a line (small region) that a phenomena occur

it is possible in a sphere region but I can not find this for a refining mesh in a cylinder or cubic region.

Do have an idea??

Kapi · February 23, 2016, 17:35

Hi Aer,

I think the only option available is "sphere of influence" specially when thr is nothing to select for sizing!

aer · February 23, 2016, 22:13

Quote:

Originally Posted by Kapi

Hi Aer,

I think the only option available is "sphere of influence" specially when thr is nothing to select for sizing!

Hi Kapi

Thanks for your reply

Also, I find only "sphere of influence" that is appropriate for refine mesh in a sphere region.

Thanks again dear

hwet · February 23, 2016, 23:10

you could go back in geometry and make a line there.

Or more technically you can adapt a region in fluent and refine the mesh there.

aer · February 28, 2016, 07:33

Quote:

Originally Posted by hwet

you could go back in geometry and make a line there.

Or more technically you can adapt a region in fluent and refine the mesh there.

hi Hwet

Thanks for your reply

February 20, 2016, 23:05	source line definition	#1
aer New Member Julia Join Date: May 2011 Posts: 20 Rep Power: 14	Hi How can I define a source line in Ansys meshing to refine the mesh near this source line? thanks alot

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
[Other] Adding solvers from DensityBasedTurbo to foam-extend 3.0	Seroga	OpenFOAM Community Contributions	9	June 12, 2015 17:18
Problem compiling a custom Lagrangian library	brbbhatti	OpenFOAM Programming & Development	2	July 7, 2014 11:32
OpenFOAM without MPI	kokizzu	OpenFOAM Installation	4	May 26, 2014 09:17
centOS 5.6 : paraFoam not working	yossi	OpenFOAM Installation	2	October 9, 2013 01:41
error while compiling the USER Sub routine	CFD user	CFX	3	November 25, 2002 15:16

February 23, 2016, 07:04		#2
hwet Senior Member Join Date: Mar 2014 Posts: 375 Rep Power: 13	edge sizing

February 23, 2016, 17:35		#4
Kapi Senior Member Join Date: Apr 2014 Location: Melbourne Posts: 584 Rep Power: 14	Hi Aer, I think the only option available is "sphere of influence" specially when thr is nothing to select for sizing!

February 23, 2016, 23:10		#6
hwet Senior Member Join Date: Mar 2014 Posts: 375 Rep Power: 13	you could go back in geometry and make a line there. Or more technically you can adapt a region in fluent and refine the mesh there.