|
[Sponsors] |
Inappropriate zone type, inability to change to interoir & skipping of zones |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 23, 2012, 10:23 |
Inappropriate zone type, inability to change to interoir & skipping of zones
|
#1 |
New Member
Taiwo
Join Date: Oct 2011
Location: UK
Posts: 21
Rep Power: 15 |
Hi all,
Please, assist me to fix these probems: Problem 1 I imported a mesh from Gambit into Fluent. The pictorial representation of the grid is attached. The cut1 & cut2 are the two holes that pass through the thickness of the strip. The strip is then inserted into the tube. The following message appeared on the console: Warning: Inappropriate zone type (interior) for one-sided face zone 5. Changing to wall. Error: Cannot change cutflow1 to interior because there is only one adjacent cell thread. Error Object: #f cutflow1 Error: Cannot change cutflow2 to interior because there is only one adjacent cell thread. Error Object: #f cutflow2 Problem 2 I imported a mesh from Gambit into Fluent. The pictorial representation of the grid is attached. (the same grid as in Problem 1). The cut1 & cut2 are the two holes that pass through the thickness of the strip. The strip is then inserted into the tube. The following message appeared on the console: Removing 1157 unreferenced faces, zone 5. Removing 1143 unreferenced faces, zone 6. Warning: Number of nodes read (349210) does not match number referenced (346734). Resetting counter to match the number referenced. Skipping zone cut1 (not referenced by grid). Skipping zone cut2 (not referenced by grid). Thanks very much. |
|
Tags |
cell, interior, node, thread, zone |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
transsonic nozzle with rhoSimpleFoam | Unseen | OpenFOAM Running, Solving & CFD | 8 | July 1, 2022 07:54 |
[Commercial meshers] Fluent3DMeshToFoam | simvun | OpenFOAM Meshing & Mesh Conversion | 50 | January 19, 2020 16:33 |
boundary conditions for simpleFoam calculation | foam_noob | OpenFOAM Running, Solving & CFD | 8 | July 1, 2015 09:07 |
[blockMesh] StitchMesh on two patches | anita | OpenFOAM Meshing & Mesh Conversion | 31 | April 4, 2013 12:51 |
Problem in running ICEM grid in Openfoam | Tarak | OpenFOAM | 6 | September 9, 2011 18:51 |