 |
 |
 |
|
|
|
[Sponsors] | ||||
February 25, 2014, 08:55
|
Gaussi analyse problem
|
#1 |
|
New Member
heiko
Join Date: Feb 2014
Posts: 4
Rep Power: 13  |
I am working on Gaussi Heat Flux,but when i change the length/w/h of model,i found the temperature change a lot,could anyone tell me the reason?here is one part of my apdl
 e.t if Ichange length/w/h all to 0.00001,there will be an warning exceeding the temp limit/prep7 /units,si et,1,solid70 *set,rb,0.00001 !element length *set,length,0.0002 *set,width,0.0002 *set,height,0.0002 r=0.00001 !radius U=20 I=2 A=4.45*0.18 P=A*U*I qmax=p/(3.14*r*r) ......... |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Other] engineFoam new mesh problem | ayhan515 | OpenFOAM Meshing & Mesh Conversion | 5 | August 10, 2015 09:45 |
| UDF compiling problem | Wouter | Fluent UDF and Scheme Programming | 6 | June 6, 2012 05:43 |
| Gambit - meshing over airfoil wrapping (?) problem | JFDC | FLUENT | 1 | July 11, 2011 06:59 |
| natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 07:29 |
| Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 20:13 |
Linear Mode
