 |
 |
 |
|
|
|
[Sponsors] | ||||
February 25, 2014, 10:59
|
Hydrodynamic Time Response
|
#1 |
|
New Member
Join Date: Feb 2014
Posts: 1
Rep Power: 0  |
Hello,
For our master thesis, we are modelling an offshore windturbine (on a monopile foundation). A first step was to make a the geometry in DesignModeler: this is done using PIPE elements. The piece of the monopile which is located under the mudline, is modeled using command snippets. The second step was to perform a modal analysis, which also worked out fine. Now we are trying to perform a hydrodynamic time response (with Jonswap wave forms); but we have no idea how to start doing this. I do know we've got to do something with the AQWA module.. Can anyone help us getting started on this? We're using Ansys V14. Thanks in advance |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transient simulation not converging | skabilan | OpenFOAM Running, Solving & CFD | 14 | December 17, 2019 00:12 |
| mixerVesselAMI2D's mass is not balancing | sharonyue | OpenFOAM Running, Solving & CFD | 6 | June 10, 2013 10:34 |
| calculation stops after few time steps | sivakumar | OpenFOAM Running, Solving & CFD | 7 | March 17, 2013 07:37 |
| pisoFoam with k-epsilon turb blows up - Some questions | Heroic | OpenFOAM Running, Solving & CFD | 26 | December 17, 2012 04:34 |
| Modeling in micron scale using icoFoam | m9819348 | OpenFOAM Running, Solving & CFD | 7 | October 27, 2007 01:36 |
Linear Mode
