 |
 |
 |
|
|
|
[Sponsors] | ||||
March 30, 2014, 06:38
|
ANSYS MAXWELL Star connected winding
|
#1 |
|
New Member
Agostino Russo
Join Date: Mar 2014
Posts: 2
Rep Power: 0  |
Hi everyone, do you work with the ANSYS Maxwell program at all?
I have a question about how to connect the three windings (transient solution) in star connection, since only one terminal can be assigned to each coil? After i make the three windings, phase A, Phase B and Phase C, how do i connect each ending terminal (bottom of the picture) together in star connection since the other terminals are already assigned? Thank you! 
Last edited by MrRusso; April 6, 2014 at 06:20. |
|
|
|
|
|
April 6, 2014, 06:09
|
Answer
|
#2 | |
|
New Member
Agostino Russo
Join Date: Mar 2014
Posts: 2
Rep Power: 0 |
Quote:
That's the connection i want to make. After I make the three windings, how do i connect them together in star connection (bottom of the picture)  ? Thank you
|
||
|
|
|
||
 |
| Tags |
| ansys maxwell, star conncted windings |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [Commercial meshers] Using starToFoam | clo | OpenFOAM Meshing & Mesh Conversion | 33 | September 26, 2012 04:04 |
| [Other] StarToFoam error | Kart | OpenFOAM Meshing & Mesh Conversion | 1 | February 4, 2010 04:38 |
| [Commercial meshers] Trimmed cell and embedded refinement mesh conversion issues | michele | OpenFOAM Meshing & Mesh Conversion | 2 | July 15, 2005 04:15 |
| ANSYS to acquire CFX | Fred | FLUENT | 0 | February 18, 2003 21:04 |
| ANSYS to acquire CFX | Fred | Siemens | 0 | February 18, 2003 21:03 |
Linear Mode
