 |
 |
 |
|
|
|
[Sponsors] | ||||
Noise pressure analysis using a sound pressure spectrum as input load |
 |
|
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
August 14, 2014, 12:28
|
Noise pressure analysis using a sound pressure spectrum as input load
|
#1 |
|
New Member
Tom Bona
Join Date: Aug 2014
Posts: 1
Rep Power: 0  |
Hey there! And thanks for reading.
I am using ANSYS Workbench / Mechanical, have my 3D geometry and need to perform an acoustic analysis to see the output results. As input, I have a dB vs frequency spectrum, but I don't quite now how to get the analysis started (using Mechanical or Fluent or other tools accessed via Workbench). Could any of you give me a hand? I would be extremely grateful! Sincere regards, Tom |
|
|
|
|
|
| Tags |
| acoustic analysis, noise, sound pressure, spl |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Monitor for Pressure BC not same as the input value ! | supermanks | FLUENT | 7 | June 3, 2014 09:02 |
| [OpenFOAM] Paraview 3.98 - errors when saving geometry file | pajot | ParaView | 1 | September 28, 2013 11:45 |
| Gas pressure question | Dan Moskal | Main CFD Forum | 0 | October 24, 2002 23:02 |
| Terrible Mistake In Fluid Dynamics History | Abhi | Main CFD Forum | 12 | July 8, 2002 10:11 |
| Hydrostatic pressure in 2-phase flow modeling (long) | DS & HB | Main CFD Forum | 0 | January 8, 2000 16:00 |
Linear Mode
