 |
 |
 |
|
|
|
[Sponsors] | ||||
January 24, 2016, 09:48
|
Flow Simulation For a electronic cooling fan
|
#1 |
|
New Member
Join Date: Jan 2016
Posts: 2
Rep Power: 0  |
im doing a simulation on small scale electronic cooling fanby using ANSYS FLuent. I wan to validate the following data 4.45CFM at 2500 RPM and 61.78CFM at 3400 RPM. How to set the boundary condition and solution in order to get the result? The result i wish to get is the mass flow rate produced by the fan. Thank you for the guidances.
|
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Jet fan and Tunnel simulation | ahlo7 | CFX | 9 | November 13, 2019 04:54 |
| how to get a time-accurate solution in Flow Simulation | drdet | FloEFD, FloWorks & FloTHERM | 4 | January 20, 2015 07:11 |
| Axial fan or blower cooling a hot object with recirculation | mariconeagles96 | CFX | 4 | April 18, 2012 08:41 |
| Flow Simulation Outlet Fan | D.Castle | FloEFD, FloWorks & FloTHERM | 0 | June 30, 2009 15:00 |
| Question concerning about the flow simulation of a fan in an engine room. | ghlee | Main CFD Forum | 3 | October 21, 1998 07:05 |
Linear Mode
