Can anyone help me to figure out why the pressure course is 0?

sy2516 · April 21, 2018, 15:22

I can see the pressure from the contour but I cannot see the pressure course in the monitor that I set up. Can anyone help me to figure out what happened?

sy2516 · April 21, 2018, 15:24

Gert-Jan · April 22, 2018, 06:04

Really don't know. Looks like a fluent thing, so I recommend to ask it in the fluent forum.
But looking at the text; you are monitoring the integral value of the total pressure in a point. Isn't that in conflict? I mean: How do you want to make an integral over a point? An integral over a surface would make sense to me...........
So why not just monitoring the total pressure value at the point?

April 21, 2018, 15:22	Can anyone help me to figure out why the pressure course is 0?	#1
sy2516 New Member Shuai Yuan Join Date: Nov 2016 Posts: 29 Rep Power: 9	I can see the pressure from the contour but I cannot see the pressure course in the monitor that I set up. Can anyone help me to figure out what happened?

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Wind tunnel Boundary Conditions in Fluent	metmet	FLUENT	6	October 30, 2019 12:23
Getting divergence while increasing the back pressure at pressure outlet	greenfields15	FLUENT	0	March 18, 2018 23:39
Outlet pressure	aja1345	FLUENT	5	August 18, 2015 11:02
Calculation of the Governing Equations	Mihail	CFX	7	September 7, 2014 06:27
Unsteady pressure differential between inlet and outlet of the pipe for single phase	joshi20h	FLUENT	0	September 26, 2012 12:41

April 21, 2018, 15:24		#2
sy2516 New Member Shuai Yuan Join Date: Nov 2016 Posts: 29 Rep Power: 9

April 22, 2018, 06:04		#3
Gert-Jan Senior Member Gert-Jan Join Date: Oct 2012 Location: Europe Posts: 1,831 Rep Power: 27	Really don't know. Looks like a fluent thing, so I recommend to ask it in the fluent forum. But looking at the text; you are monitoring the integral value of the total pressure in a point. Isn't that in conflict? I mean: How do you want to make an integral over a point? An integral over a surface would make sense to me........... So why not just monitoring the total pressure value at the point?