[ddemiroguzhan]

Greetings,

I am trying to make a 2-way acoustic FSI in Ansys workbench. After I have set the problem up, when I started the calculation, no errors occur. But, after a while, when I try to stop the analysis (to check the interval data that is written by the acoustic probes which are specified in Fluent part), it does not stop. I have tried to use ctrl+c, also tried to shut the processors from the task manager (mp_fl...exe) but it did not work.

Also, sometimes it stops without a warning. I mean, the analysis seems to be going but the data is not written after a specific time. And that specific time changes every time this problem happens, so it is not likely to be causing from the time-step or the analysis itself.

If you have any suggestions about how to prevent Ansys system coupling analysis to stop without a warning but seems to be going, I'll appreciate it very much!

Thanks in advance,

Note: Analysis is running as parallel on my PC.


Oguzhan