 |
 |
 |
|
|
|
[Sponsors] | ||||
December 13, 2020, 06:01
|
Help with meshing
|
#1 |
|
New Member
Join Date: Nov 2020
Posts: 1
Rep Power: 0  |
Hi, I am new to ansys and i am trying to simulate a synthetic jet in 2D. I Have created the geometry using Design modeller and meshed using Ansys Meshing. However, I have a small problem. My geometry consists of an edge with part of the said edge being a heater element. I want to name that part of the edge with a seperate named selection but i want the entire edge to be considered as a single edge while giving no.of divisions and biasfactor. How can I do this?
|
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| [ANSYS Meshing] only automatic meshing works, | kazra | ANSYS Meshing & Geometry | 2 | February 23, 2017 11:38 |
| [ICEM] Flow channel meshing problems | StefanG | ANSYS Meshing & Geometry | 19 | May 15, 2012 06:44 |
| [ANSYS Meshing] Meshing strategy for External Flows | Hybrid | ANSYS Meshing & Geometry | 0 | January 24, 2012 14:27 |
| Best Meshing scheme for Cylinder | Nutrex | Main CFD Forum | 4 | July 29, 2008 11:03 |
| Volume Meshing & Face Meshing? singularity of grid | ken | FLUENT | 0 | September 4, 2003 11:08 |
Threaded Mode
