 |
 |
 |
|
|
|
[Sponsors] | ||||
June 20, 2021, 14:05
|
ANSYS Polyflow incomplete streamline
|
#1 |
|
New Member
Tan Jun Ying
Join Date: Jun 2021
Posts: 5
Rep Power: 4  |
I am new to ANSYS and currently working on single screw extrusion simulation. The streamline is only appear at the inlet but it does not complete the path until outlet.
I have tried to increase the mass flow rate, temperature imposed, larger number of iteration, or changing it to slip condition... but none of it is helping... May I know what could be the possible mistake? I am very appreciate for your help. |
|
|
|
|
|
June 20, 2021, 19:08
|
Send a picture of the settings in CFD Post processor
|
#2 |
|
New Member
Burhan Shuaib
Join Date: Jun 2021
Posts: 6
Rep Power: 4 |
Maybe you have selected a single plane in your setting for streamline in CFD Post processor.
Try inserting vectors from inlet to outlet to see if that solves the issue. Regards, Fellow peer working on Polyflow too. |
|
|
|
|
|
|
June 20, 2021, 23:57
|
|
#3 | |
|
New Member
Tan Jun Ying
Join Date: Jun 2021
Posts: 5
Rep Power: 4 |
Quote:
I used 3D streamline and make it start from inlet. I tried to insert vector, it also only appear at the inlet. |
||
|
|
|
||
|
June 22, 2021, 01:01
|
Problem solved
|
#4 |
|
New Member
Tan Jun Ying
Join Date: Jun 2021
Posts: 5
Rep Power: 4 |
Thanks all, problem solved. I guess is my screw clearance is too small so the plastic can't flow and only appear at inlet.
|
|
|
|
|
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ansys Polyflow | Dansys | ANSYS | 3 | June 20, 2021 19:12 |
| Is there any other way to get Polyflow other than ANSYS? | dsaen | ANSYS | 0 | April 23, 2018 12:54 |
| long error when using make-install SU2_AD. | tomp1993 | SU2 Installation | 3 | March 17, 2018 06:25 |
| Ansys HPC licensing policy | assafwei | ANSYS | 0 | June 29, 2014 16:00 |
| Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 01:10 |
Linear Mode
