|
[Sponsors] |
July 22, 2021, 05:56 |
Setting AQWA model using jscript macros
|
#1 |
New Member
Hardik Patil
Join Date: Jul 2021
Posts: 1
Rep Power: 0 |
Hi,
I have been trying to automate hydrodynamic diffraction analysis of a boat by writing workbench, design modeler and AQWA scripts and run the whole analysis from command prompt. I have managed to write a jscript macro for the design modeler, thanks to other posts in this forum which outline a method of calling different commands for DesignModeler. However, I have been looking for a similar set of instructions for the AQWA module and haven't found anything yet. I know I can find functions in the [anyspath]\aisol\aqwa\AQWApages\scripts, but do not know ways to call them. I'll be really grateful if someone can help me out with achieving this or point towards relevant resources since the official user guides and scripting guides have not been of much use yet. Thank you! |
|
Tags |
ansys, aqwa, jscripts, macros, scripting |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
simpleFoam tutorial PitzDaily using Reynolds stress tensor (LRR RASModel) | dlahaye | OpenFOAM Running, Solving & CFD | 24 | August 4, 2023 14:29 |
Table bounds warnings at: END OF TIME STEP | CFXer | CFX | 4 | July 16, 2020 23:44 |
[swak4Foam] swakExpression not writing to log | alexfells | OpenFOAM Community Contributions | 3 | March 16, 2020 18:19 |
manualInjection model in sprayFoam | Mentalo | OpenFOAM Running, Solving & CFD | 1 | April 2, 2014 09:29 |
Setting of Spalart–Allmaras turbulence model | Naruto | OpenFOAM Pre-Processing | 0 | March 31, 2014 13:00 |