|
[Sponsors] |
May 21, 2024, 08:13 |
Ansys Polyflow
|
#1 |
New Member
Ali
Join Date: Mar 2023
Posts: 2
Rep Power: 0 |
Hello Dear
I want to simulate a problem in Ansys polyflow. after updating the setup with polyflow.dat this error occurred : MESH INFORMATION Read from non-native mesh format Length unit : _meter_ 12844 Ele; 15092 Vert; 2 Sub Dom; 6 Bnd. Sets; PART_1_1_SOL => PART_1_1_SOL 2197 elem. PART_1_2_SOL => PART_1_2_SOL 10647 elem. DIE_WALL => DIE_WALL 338 faces FREE_SURFACE => FREE_SURFACE 1638 faces INLET => INLET 169 faces OUTLET => OUTLET 169 faces SYMMETRY_1 => SYMMETRY_1 988 faces SYMMETRY_2_ => SYMMETRY_2_ 988 faces *** ERROR IN * ENRUN1 * *** Found at least one task type not supported by current license! (found Steady-state task.) Please check the contents of the Output Text Window. We must leave Polydata now. We apologize for the inconvenience. (error code #384 detected) please help me to fix this error. Last edited by alishooshtari; May 21, 2024 at 09:20. |
|
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Ansys Polyflow | Dansys | ANSYS | 3 | June 20, 2021 20:12 |
Ansys Polyflow - problem with simulation | RogAdri | ANSYS | 0 | January 4, 2019 06:46 |
Running Ansys in BAtch Mode | kuleuvenstudent | ANSYS | 1 | October 18, 2017 13:11 |
Ansys HPC licensing policy | assafwei | ANSYS | 0 | June 29, 2014 17:00 |
Exporting results from CFX to ANSYS ?? | sohail ahmed | CFX | 1 | December 20, 2007 02:10 |