liquid decreases in bubble column E-E simulation

jhchen · January 24, 2010, 21:19

Hi, I have a problem in bubble column simulation. the column is 0.1 m in diameter and 2m in height. Initially quiescent water is filled at the lower half. the gas is introduced at the bottom. The top surface is set as pressure outlet. k-eps model(mixture version) and QUICK scheme is used.
Question is: at heigher Ug(>0.1 m/s), the liquid will decrease dramatically, but not because entrainment since I have monitored the flux on outlet.
I guess some convegence problem causes this problem. Possibly the gas cap above the liquid bulk region, the backflow settings about the pressure outlet BC may be potential sticking points.

would u help me? Welcome constructive discussions.

ps: I know the degassing BC and it seems not practical for the simulation with gas cap. I have also extend the simulation domain but it doesn't help.

Simon Hans · August 3, 2010, 10:49

Did you set a minumum vf for the liquid phase? In that case your mass balance will not be satisfgied in regeions where vf_liq should go to zero

January 24, 2010, 21:19	liquid decreases in bubble column E-E simulation	#1
jhchen New Member Join Date: Sep 2009 Posts: 1 Rep Power: 0	Hi, I have a problem in bubble column simulation. the column is 0.1 m in diameter and 2m in height. Initially quiescent water is filled at the lower half. the gas is introduced at the bottom. The top surface is set as pressure outlet. k-eps model(mixture version) and QUICK scheme is used. Question is: at heigher Ug(>0.1 m/s), the liquid will decrease dramatically, but not because entrainment since I have monitored the flux on outlet. I guess some convegence problem causes this problem. Possibly the gas cap above the liquid bulk region, the backflow settings about the pressure outlet BC may be potential sticking points. would u help me? Welcome constructive discussions. ps: I know the degassing BC and it seems not practical for the simulation with gas cap. I have also extend the simulation domain but it doesn't help.

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Turbulent boundary conditions for bubble column	anjai	FLUENT	12	October 17, 2005 06:34
simulation of taylor bubble	merrouche djemai	Main CFD Forum	0	December 18, 2002 04:34
compressible liquid simulation	kaiser	Main CFD Forum	0	October 13, 2002 04:32
Simulation of bubble growth	Jean van der Merwe	Main CFD Forum	3	May 1, 2001 19:40
Gas Bubbling through Liquid Column	marakib	FLUENT	0	March 18, 2001 08:19

August 3, 2010, 10:49		#2
Simon Hans New Member Simon Hans Niemann Join Date: Mar 2009 Location: Geleen, Netherlands Posts: 2 Rep Power: 0	Did you set a minumum vf for the liquid phase? In that case your mass balance will not be satisfgied in regeions where vf_liq should go to zero