 |
 |
 |
|
|
|
[Sponsors] | ||||
June 6, 2011, 10:24
|
Two or Three Dimensional for a coil
|
#1 |
|
Senior Member
Mehdi Asghari
Join Date: Feb 2010
Posts: 127
Rep Power: 16  |
Hi all;
I have a coil with a circular cross section according to the following attached pattern . Just As anybody observes, this pattern has two returns (two elbow couple). My question is if I can model this problem by a two dimensional model or I have to model this example by a three dimensional one. The boundary conditions are same for every cross section. If your answer is ok, Please lead me how to consider this configuration. Thanks a lot for any help. M.asghari Drawing4.jpg |
|
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Please help with Non dimensional analysis | rosol | FLUENT | 2 | June 16, 2007 13:07 |
| heat transfer: air in a room and water in a coil | Alberto | CFX | 2 | May 9, 2006 09:56 |
| importing geometry from three dimensional subject | George Kagadis | FLUENT | 0 | September 30, 2004 01:35 |
| Coil | tuki72 | CFX | 3 | February 26, 2004 16:23 |
| Non Dimensional Parameters | J.J | Main CFD Forum | 1 | June 28, 2000 20:12 |
Threaded Mode
