|
[Sponsors] |
October 6, 2011, 12:41 |
Slug flow boundary condition
|
#1 |
New Member
Dave Wang
Join Date: Oct 2011
Posts: 1
Rep Power: 0 |
Hi there,
I have some questions about boundary condition set-up for slug flow simulation using Fluent VOF model: How to set up inlet boundary condition when simulating slug flow in a horizontal pipe? Do I need to physically insert a split plane to separate the interface at the inlet? fine meshing for the split interface area? top for gas inlet and bottom for liquid inlet? Kind regards, |
|
Tags |
inlet, slug flow, vof |
Thread Tools | Search this Thread |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
mass flow in is not equal to mass flow out | saii | CFX | 12 | March 19, 2018 06:21 |
Boundary condition for exhaut flow with imposed mass flow | stephane | FLUENT | 1 | November 24, 2011 03:04 |
Volume of Flow Rate (VFR) boundary condition | therockyy | FLOW-3D | 0 | May 23, 2011 15:19 |
RPM in Wind Turbine | Pankaj | CFX | 9 | November 23, 2009 05:05 |
How can apply mass flow rate boundary condition? | Sima | Phoenics | 1 | December 1, 2007 19:55 |