|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Bruce Tan
Join Date: Dec 2011
Posts: 4
Rep Power: 13 ![]() |
This is my pressure plot in my attempt to analysis the fluid flow in Venturi Tube. I am wondering if my result is correct or not. The fluid flow within the Venturi Tube is set to be laminar and negative pressure occur at the throat section. The hole represent the tapping for manometer. Any opinion and advice are welcome, Appreciated it^^ |
|
![]() |
![]() |
![]() |
![]() |
#2 |
Super Moderator
|
||
![]() |
![]() |
![]() |
![]() |
#3 |
New Member
Bruce Tan
Join Date: Dec 2011
Posts: 4
Rep Power: 13 ![]() |
The pressure is still lowest at the throat section. I setting the inlet section as velocity inlet and outlet section as pressure outlet, no boundary condition are set for the tapping hole. Is this correct way?? Because I want to found out the static hole error cause by the tapping hole on Venturi Tube.
|
|
![]() |
![]() |
![]() |
Tags |
laminar flow, pressure, venturi |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to plot pressure drop with Periodic BC? | bigfans | FLUENT | 7 | November 8, 2016 11:28 |
pressure gradient plot | Angeline | FLUENT | 0 | November 26, 2010 01:16 |
Pressure Rise Error | emueller | CFX | 0 | May 5, 2009 11:08 |
how to plot the average pressure over each period? | Tsui | Phoenics | 1 | June 5, 2008 09:16 |
plot pressure distribution on a section of 3D wing | ROOZBEH | FLUENT | 3 | April 21, 2008 03:30 |