 |
 |
 |
|
|
|
[Sponsors] | ||||
May 4, 2016, 09:47
|
Air entrapment issue for CFD
|
#1 |
|
New Member
MI - Michigan
Join Date: May 2016
Posts: 1
Rep Power: 0  |
What is the proper way to simulate a flow through a pipe with air ratio (5%) in oil using CFD?
I tried to use equivalent density, viscosity and bulk modulus for the mixed air/oil in CFD material setup. As soon as I changed the fluid bulk modulus for simulating air entrapment in oil, Autodesk Simulation CFD crashed. Is it because of violation of "incompressible" requirement? |
|
|
|
|
 |
| Thread Tools | Search this Thread |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Data Center Air conditioning Boundary Condition problem | jaypatel | OpenFOAM | 9 | April 8, 2020 15:04 |
| Air Entrainment Model | atulverma | FLOW-3D | 7 | December 23, 2017 02:53 |
| Radiation interface | hinca | CFX | 15 | January 26, 2014 17:11 |
| Air to Air Heat Exchanger | visser1975 | FLUENT | 2 | November 10, 2012 13:34 |
| Kinetic air props model - conductivity HALF? | Chris Bailey | FLUENT | 1 | March 7, 2006 10:38 |
Linear Mode
