|
[Sponsors] |
![]() |
![]() |
#1 |
New Member
Adrian
Join Date: Mar 2018
Posts: 2
Rep Power: 0 ![]() |
Hello,
i have to build 2 different inlets for an coaxial pipe-system. i can fill the inner area/circle of the pipe as a surface, but then i can not fill just the outer "ring", becaus CFD fills the hole area/surface/circle across the inner surface. Both pipes are starting at the same point. any idea how can i solve this problem without changing the geometry ? thx |
|
![]() |
![]() |
![]() |
Thread Tools | Search this Thread |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
[DesignModeler] Problem in filling Surface geometry | voldemort | ANSYS Meshing & Geometry | 0 | June 26, 2016 12:47 |
New boundary condition available | mbeaudoin | OpenFOAM | 8 | January 27, 2016 14:06 |
tank filling problem with compressible air | Cle | FLUENT | 1 | March 8, 2012 23:02 |
natural convection problem for a CHT problem | Se-Hee | CFX | 2 | June 10, 2007 06:29 |
Adiabatic and Rotating wall (Convection problem) | ParodDav | CFX | 5 | April 29, 2007 19:13 |