|
[Sponsors] |
November 22, 2013, 17:30 |
batch job
|
#1 |
Member
shahrbanoo
Join Date: Mar 2013
Posts: 63
Rep Power: 13 |
Hi
I,ve started meshing with Fame engine pluse with single processor. but it takes a long time to be finished. how can I stop meshing?(of course I did it, but the crank angles that where had been meshing, were not meshed after again starting a new mesh) and start a new one with batch job? I did all of this but batch job doesn' work and it's meshing with a single processor. |
|
November 23, 2013, 06:04 |
|
#2 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
Hi...
Why? If you stop FEP your system finishes the meshing process. You can delete a file ;that I don not know its name exactly; in the mesh folder and start a new meshing. moreover, I think V.2008 is not able to use 2 cores at the same time but V.2011 can. best regards SH.SH amin -u50 |
|
November 23, 2013, 13:37 |
|
#3 |
Member
shahrbanoo
Join Date: Mar 2013
Posts: 63
Rep Power: 13 |
Hi
thanks dear amin_u50 for u'r answer so I have to install Fire 2011 in near future!! I have another problem now: In the meshing process, I stopped meshing for changing the mesh setting and convert single processor to batch job, but I didn't succeed and the interval(i.g 475-485) had not been meshed and the intervals after that had been meshed. now I have 10CA that is not meshed! what should I do for meshing it? |
|
November 24, 2013, 07:18 |
|
#4 |
Member
shahrbanoo
Join Date: Mar 2013
Posts: 63
Rep Power: 13 |
I found how to do it!
so simple!! |
|
November 24, 2013, 11:02 |
|
#5 |
Senior Member
amin u3fi
Join Date: Feb 2013
Posts: 137
Rep Power: 13 |
congratulation
|
|
December 15, 2013, 12:08 |
|
#6 |
New Member
mehdi
Join Date: Dec 2013
Posts: 2
Rep Power: 0 |
hi guys!
im recently working by fame engin plus.any body knows in fame engin plus at input surface section what is the range of cranck angle(valid from... to... cranck angle)? |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Stopping a Fluent batch job AND saving the data! Possible? | Volker Pawlik | FLUENT | 13 | December 28, 2020 04:16 |
FLUENT Batch job | Saravanan | FLUENT | 11 | May 14, 2014 16:47 |
[Question]About batch job | fluboy | FLUENT | 2 | August 12, 2009 11:10 |
How to specify the iterations of a batch job | Consol | Main CFD Forum | 0 | October 18, 2008 23:42 |
Running Job in Batch mode (EFD) | Nick Sessions | FloEFD, FloWorks & FloTHERM | 0 | April 16, 2008 16:44 |