|
[Sponsors] |
May 21, 2015, 09:59 |
injection modeling
|
#1 |
Member
Join Date: Aug 2014
Posts: 31
Rep Power: 11 |
Hi
I wanna to simulate injection in avl-fire.... I set all setting but when I define table for injection rate, half cone diameter and particle sizes....and press "start calculation" calculation finishes instantly and i dont get result but when I define constant number the program simulate spray anyone know how should i do? "Spray>>modules>>Particle introduction methods>>nozzles>>diagram>>injection rate, half cone diameter and particle sizes" thanks |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to go about modeling injection nozzle two phase flow in FLUENT? | skonda2 | Fluent Multiphase | 0 | March 17, 2015 07:52 |
injection problem | Mark New | FLUENT | 0 | August 4, 2013 01:30 |
modeling de-moisturization of a plaster mould by air injection in CFX | sakalido | CFX | 6 | February 16, 2012 18:19 |
Modeling plastic injection process in CFX. | psicosis_x | CFX | 2 | April 13, 2011 14:04 |
modeling injection | abel | FLUENT | 0 | May 7, 2005 04:06 |