|
[Sponsors] |
Extrusion (between a half-sphere and a plane) |
|
LinkBack | Thread Tools | Search this Thread | Display Modes |
June 28, 2004, 10:44 |
Extrusion (between a half-sphere and a plane)
|
#1 |
Guest
Posts: n/a
|
Hello,
I need to do the mesh of a fluid between a sphere and a plane. I use Prostar. For the moment, I have a 2D patch in a square whose top is a half circle. I tried to use the VCEX command with a spherical coordinate system, but as I had expected the mesh obtained had a spherical surface at the top (that is what I want) but at the bottom too (and I want a plane). Does somebody know if it is possible to extrude between 2 surfaces, or two splines? Or if you have other suggestions... Thank you. Aline |
|
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
3D geometry of round particles in a 2D half plane | Stefan Zigan | Main CFD Forum | 0 | January 10, 2008 04:00 |
The 'other' half of the continuity equation | desA | Main CFD Forum | 10 | February 7, 2007 07:35 |
Half the cpu | r2d2 | OpenFOAM Running, Solving & CFD | 3 | July 13, 2005 09:26 |
Oddity in meshing half a torus | Maarten | FLUENT | 0 | March 12, 2004 08:04 |
3d and half model | nikita | FLUENT | 0 | April 22, 2003 03:41 |